Affect factors of cutting effect of CNC panel saw

1. The guide rails of CNC panel saw are usually circular and square. The guide rail plays an important role in guiding. The balance and straightness of the saw car running on the guide rail are determined by the guide rail. Only if the guide rail is hard enough and flat enough, can the good straightness of the sawing board be ensured. When the hardness of the guide rail of the sliding table saw is not enough, there may be some small details such as the clearance of the guide rail device, which will deform and directly affect the cutting accuracy.

2. The imported rack and pinion mode is adopted for the saw, with high-precision surface grinding, stable transmission and long-lasting durability; the heavy-duty frame, after failure treatment, is durable and stable. The running stability of the saw is very important. It is necessary to observe the axis of the electronic cutting saw. As long as the problem of the guide rail is eliminated, the wear status of the copper wheel is checked. Once the wear degree of the copper wheel is found to be different, the sawing machine will be affected and the cutting effect will be affected.

3. Observe whether the big and small blades of the CNC panel saw are in the same straight line. When the push table saw works, open the small saw and cut with the large saw. If the two saw blades are not in the same position and the cutting cuts are not consistent, the cutting results can be imagined. When installing the saw blade, keep the shaft center, chuck and flange clean. The inner diameter of the flange is consistent with the inner diameter of the saw blade. Ensure that the flange plate is closely connected with the saw blade. Install the positioning pin and tighten the nut. The size of the flange should be appropriate, and the outer diameter should not be less than 1 / 3 of the saw blade diameter. Check whether the saw blade is damaged, whether the tooth profile is complete, whether the saw plate is smooth and smooth, and whether there are other abnormal phenomena, so as to ensure the use safety.

4. Before starting work, it is necessary to carry out a comprehensive inspection on the CNC panel saw. It is necessary to check whether the connecting bolts of each part of the CNC panel saw are loose, whether the transmission device of the CNC panel saw is running smoothly, whether each button of the CNC panel saw is normal, and whether the lubrication system, pneumatic system and various safety systems of the CNC panel saw are complete well. When these have been checked, there is no problem before the normal start-up operation.